This simple circuit uses an incandescent lamp to detect airflow. With the filament exposed to air, a constant current source is used to slightly heat the filament. As it is heated, the resistance increases. As air flows over the filament it cools down, thus lowering it's resistance. A comparator is used to detect this difference and light an LED. With a few changes, the circuit can be connected to a meter or ADC to provide an estimation on the amount of air flow.
Schematic
Parts:
Part
Total Qty.
Description
Substitutions
R1
1
100 Ohm 1/4W Resistor
R2
1
470 Ohm 1/4W Resistor
R3
1
10k 1/4W Resistor
R4
1
100K 1/4W Resistor
R5
1
1K 1/4W Resistor
C1
1
47uF Electrolytic Capacitor
U1
1
78L05 Voltage Regulator
U2
1
LM339 Op Amp
L1
1
#47 Incandescent lamp with glass removed (See "Notes")
D1
1
LED
MISC
1
Board, Wire, Sockets for ICs, etc.
Notes:
1. The glass will have to be removed from L1 without breaking the filament. Wrap the glass in masking tape and it in a vise. Slowly crank down until the glass breaks, then remove the bulb and carefully peel back the tape. If the filament has broken, you will need another lamp.
:: موضوعات مرتبط:
،
، :: برچسبها:
مدار آشکارساز جریان هوا,
جریان هوا,
ما در این وبلاگ تلاش داریم تا با معرفی تکنولوژی های برتر روز دنیا به جوانان و علاقه مندان به علم در این مرز و بوم آریایی و علم دوست، قدمی کوچک در جهت انقلاب علمی دانشمندان بزرگ ایران عزیز برداریم. با آرزوی موفقیت.
تبادل لینک هوشمند برای تبادل لینک ابتدا ما را با عنوان مطالب برتر علمی دنیا و آدرس chortke.LXB.ir لینک نمایید سپس مشخصات لینک خود را در زیر نوشته . در صورت وجود لینک ما در سایت شما لینکتان به طور خودکار در سایت ما قرار میگیرد.